A Self Watering Planter (One Print in Spiral Vase)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Orientacyjna cena wydruku pliku
3,14 € – 3,83 € netto (bez VAT)
Dla pliku: Hexagonal_OnePart_Planter_100W100H_0.2mm_PLA_MK3_3h19m.gcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 3,48 € netto (środek widełek).
- Masa podana przez autora
- 47 g
- Czas druku podany przez autora
- 3,32 godz.
- Materiał u źródła
- PLA
- Materiał wyceny
- PLA
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
A single piece/print design of the ever-present self-watering planter.
- Ocena
- 5 / 5
- Polubienia
- 197
- Pobrania
- 709
- Wydruki
- 5
- Wyświetlenia
- 3586
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
These parts are designed to use a few solid layers on the bottom and then a continuous and unbroken profile all the way up the part. Prusa and Slic3r call this vase mode, while Cura calls it spiralize.
A single piece/print design of the ever-present self-watering planter. Saves all the folderol of multiple prints and also saves a whole bunch of time. Since it's a vase mode part, the wall speed is the only setting that significantly affects the print time. I can't advise printing at over 40mm/s and you'll get better prints at slower speeds.
Printing times (approximate):
140W190H: 7-8 hours
100W140H: 4-5 hours
80W100H: 2-3 hours
The parts will be very sensitive to scaling, due to a double-back on one of the walls. A few percent either way should be okay, but consult your layer preview. If you have a size you would really like to print, just let me know and I can configure a new file.
Print Settings
In Prusa Slicer, you will need to go into Print Settings > Advanced > Slice gap closing radius, and change it to 0.001mm.
Rafts:
No
Supports:
No
Layer Height:
0.2mm
Infill:
N/A
Nozzle Diameter:
0.4mm
Line Width:
0.6mm (over extrusion for a thicker wall)
Top/Bottom Layer Width:
0.4mm (I've found this necessary in order to achieve a water tight base)
Bottom Layers:
5
Inner/Outer Wall Print Speed:
<40mm/s
Spiralize Outer Contour:
Yup