Nozzle Brush 9000 - No bridging, no support, 13.5cm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Zero bridge, zero support, shorter noozle brush. Fits in Ender 3 Storage drawers.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 70
- Wydruki
- 4
- Wyświetlenia
- 427
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This Nozzle brush is has the head flipped so there is no need for any support or bridging.
I also shortened it to 13.5cm so it fit in the Ender 3 storage drawers.
It's a remix of a remix since most of the work was already done. I Just needed to tweak a few things to get it the way I wanted it.
My print settings
.2mm layer height
20% cubic infill
I used outer wall .4mm and inner .6mm for a bit more rigidity but 2 walls at .4mm is probably fine since the one I printed is solid!
As with the other Nozzle brushes I used sticky felt pads folded in two and wedged together to hold them in place. Cheap and easy to replace.
Heat Noozle, scrub with Noozle Brush 9000, Profit.