1 / 8
Open MVS advanced printable case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Advanced, easy to print case for the Open MVS consolizing kit. Fits Prusa i3 printers.
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 437
- Wydruki
- 4
- Wyświetlenia
- 3611
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (37)Wydruki i komentarze (Wydruki: 4) (Komentarze: 16)Remiksy (1)Kolekcje (36)Powiązane
Having troubles to print the official case? Is your built volume to small? Just wanted something fancier? Try the Open MVS advanced case!
Design goals of this case
- exact fit for the OMVS kit to consolize a Neo Geo MV1C
- printable on a Prusa i3
- fully optimized for easy, support-free printing with some sacrificial bridges
- all top surfaces to be printed directly on print bed for an uniform (textured) appearance
- good print quality even on .3mm layer height
- fancier look, with design hints taken from the AES
- easy, screw-based assembly
Additional parts needed
- 6 x 7mm M3 (or equivalent) bolt
- 18 x 10mm M3 (or equivalent) bolt
- 12 x M3 (or equivalent) hexnut (locknuts or locknuts recommended)
- 3 x 20mm M3 (or equivalent) bolt
- 3 x 38mm M3 (or equivalent) bolt
- 1 x panel mount barrel plug, equivalent to conrad.de 1582355 - 62
- 1 x LED (5mm)
- 4 x self adhesive rubber feet
Additional info
- lit part of logo can be cast from hot glue in the part logo_led_mould
- drop cast part in isopropanol to ease separating it from the mould
- make sure to print all bottom parts with same layer height, so they align perfectly
- remove original audio amplifier and heat sink
- replacement battery has to be installed flush or angled
- check space around capacitor AC11, mount laying on its side if needed
- for large printers, a single-piece bottom part is provided