Low-Poly Eevee reinforced
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a quick remix of the great low-poly eevee by @flowalistik to address two common issues mentioned in the…
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 34
- Wydruki
- 1
- Wyświetlenia
- 315
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a quick remix of the great low-poly eevee by @flowalistik to address two common issues mentioned in the comments.
- Ears easily break,
- front legs easily break.
These issues are more severe, when you want to downscale the model.
Here, the ears are separate parts, and require assembly. No glue needed normally. When printed with a decently adjusted printer (and scaled a bit smaller than the body), it should be possible to insert the ears into their sockets with two fingers and some moderate force.
As separate parts, the advantage is, that we can print them flat, which makes them almost unbreakable (at least, when done in PETG).
The lower part of the front legs are connected with a 1mm wide and 3mm high piece with the body. While not exactly anatomically correct, this helps keeping the legs in place during print, and also later, when playing. The extra geometry is decently hidden.
The ears were separated in FreeCAD with the Split Apart function of the Parts workbench.
The resulting surfaces were extruded on both the ears and the body. At the ears the extrusion was fusioned, at the body, the extrusion was subtracted.
I am printing the body at scale 55%, and the ears at scale x,y 50%; z 40% to give sufficient room for assembly. See the 3mf file for a print file with these settings.
Category: Creatures