Bee In Love Napkin/Trivet Holder v.1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
First version of a napkin or trivet holder, fixed and moving versions
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 240
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
The wife asked me to make a napkin holder. I found a neat design online so I recreated it… a bee with a little heart in the path. I remade it in fusion, and determined it was actually not a very easy task. I made a spline and wrapped it around, cut it evenly, and filleted the ends. What a disaster. Half the little good and plenty hot dogs were opened, so they didn't create faces that I could extrude through the design. I spent hours remaking them. The bee took surprisingly no time at all, but the splines fell apart on it as well.
Anyway, the trivet rack is fixed. It was the first attempt. The napkin holder is the second attempt, but I found it was too short. Both are made with PLA, and I needed to use a M3-30mm bolt for the two sides on the napkin holder.
After making the napkin holder, I discovered the moveable side just fell down, which made it a little hard to work with.
I figured someone might be able to use this, so I posted it, but I'm going to post a remix with the revised napkin holder that finally worked for anyone who wants that.