Raspberry PI RPI4 noctua NF-A4x20 fan case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Raspberry PI 4 case with Noctua NF-A4x20 fan to provide good cooling.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 1
- Wyświetlenia
- 514
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Based on the excellent case by Pillar I changed it to suit my SSK External 128GB Portable SSD, USB 3.1 Gen2 (6Gbit/s) SSD External Disk. It needed to be just 1mm taller.
I ordered a short USB to usb-C cable with angled connector because the regular connector is to long to fit inside the case (maybe diagonal it would fit but no room for storing the cable).
Just print vent_grid_plus_1mm.stl, pi_support.stl and body_without_ssd_plus_1mm.stl.
Roll up the cable to fit next to the SSD and have minimal length outside.
I used M2.5 BHCS 6mm screws for the pi. I first screw them in to create a thread and then add the Pi en screw that in.
I used M3 screws 4mm on the back.
Temperature went down from 70 degrees celsius (and cutting out) with just a flat big heatsink to 35-40 degrees celsius.