James Webb Decoration, Flat Edges

These files ensure that all edges of the final product have a flat edge without the holes.

Instructions:

• Print 1 “webb center” from the original model
• Print 6 “webb outer” from the original model
• Print 6 “webb outer_2o_1i_print6” from this remix
• Print 6 “webb_outer_3o_1i_print6” from this remix
   

Assembly Instructions:

• Upside down, put together the inner loop
• Upside down, put together the outer loop
• Place the inner loop on the outer loop, and use a rubber mallet if needed
• Place the center piece in the middle and use a rubber mallet if needed

I've seen feedback here and on Reddit that people have had trouble fitting the parts together. The tolerances are intended to be very tight, and I simply followed that from the original model. Good luck, and don't be afraid to use a little force :).

Other suggestions / comments:

• Align the seam to ensure it isn't noticeable
• Add a topfill pattern “monotonic” to ensure the top layers are smooth and don't distract from the mirrors
• IF you order the mirrors that are peel and stick, I highly suggest you super glue them instead. Otherwise, you'll have 90% of the sticky side not actually sticking to anything.
• I printed at .20, and the tolerances are extremely tight to ensure a strong hold / no gaps. I used a rubber mallet for fit.
• I used 4x velcro command strips to stick to the wall, not the included keyhole.