Snow Trooper Helmet / Flame Thrower
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Thanks to Geoffro and Killonious for inspiring me to look at improving the finish on my models.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 114
- Wydruki
- 0
- Wyświetlenia
- 473
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Masks
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Thanks to Geoffro and Killonious for inspiring me to look at improving the finish on my models. My obsession with 3D Modeling and 3D printing started less than 8 months ago and I am enjoying increasing my skill level each and every day. I look back at my previous work and feel like I need to go back and renovate them all. Perhaps I will over time : ). Thanks again guys, I appreciate all and any advice no matter how critical. Cheers Jace
Ok Just added the split files and knoticed the helmet seamed small so I have increased the size of the helmet to 276mm W x 321mm H & 335mm deep. If you think this is to big or to small you will need to increase or decrease these files % wise to get the size helmet that best suits you.
Good luck ; ) Cheers Jace
"Armour still to come : )"