1 / 3
AirTag Holder for Quad Lock handlebar phone mount — zdjęcie 1
1 / 3

AirTag Holder for Quad Lock handlebar phone mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This low profile AirTag holder mounts to the bottom of the Quad Lock out front phone mount

Ocena
5 / 5
Polubienia
53
Pobrania
141
Wydruki
1
Wyświetlenia
3795
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This low profile AirTag holder mounts to the bottom of the Quad Lock out front phone mount using the holes meant for the go-pro adaptor.

You will need to pick up two M3-0.5 x 6mm socket cap screws (I got a bag of 3 Everbilt branded ones from Home Depot for 89 cents).

Once I screwed it on and placed the AirTag inside I sealed the lid on using hot glue. When it comes time to change the battery, I plan on breaking it apart and printing another one.

It's a tight fit so the AirTag doesn't rattle but that also means the little speaker isn't very audible (just in case that's a deal breaker).

Just in case you want to design something yourself I included a picture of the mounting pattern with measurements in mm.

Print Settings:

  • 30% infill
  • no supports (you may need to flip the lid so the 45 degree bevel is on the bottom)
  • Cura's default standard resolution (0.2mm layer height)
  • the pictured part was printed on an ender 3 v2 using Overture Matte Black filament

 

Important notes on gcode:

The files were sliced with a 90.9% flow rate after an initial 100% layer. That's what works best with my printer after calibrating e-steps. Unless you have an ender 3 v2 that behaves the same way, you should definitely slice the model yourself.

Tagi