1 / 4
Raspberry Pi Enclosure - Case for a Pi, Battery, Charge/Boost Board , WiFi, Fm Transmitter with External Antenna and whatever else can be crammed into it much like the Marx Brother's cabin in A Night At The Opera
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based off of http://www.thingiverse.com/thing:238154 Covers up the large openings on the side Adds a system for simple…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 460
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
- Based off of http://www.thingiverse.com/thing:238154
- Covers up the large openings on the side
- Adds a system for simple mounting options
- Opening for cables/charging and an external FM antenna, Both the opening for the antenna and the cables can be closed off with calking or the like.
- Plenty of room for sensors, speaker, mic, etc etc etc One of the pictures above shows V.02 stuffed with a RasPi B+, Adafruit's Powerboost 500C, LIIon 3.7V 4400mAh Battery. USB RTL2832 w/R820T, USB WiFi (802.11b/g/n) Module with Antenna and an Adafruit Stereo FM Transmitter with RDS/RBDS Breakout - Si4713....not fully assembled..nor tested...ymmv.
Use Case :
- LibraryBox with Battery
- FM Transmitter
- SDR Master
- All of the above
Change Log :
- V .03 Made the top 1% larger to see if it will close better
- V .02 Added hole for charging cable option
- V .01 Moded original model to include mounting options and to fill in the sides.
Inspiration :
Instructions
Print with supports on. I am futzing with getting the top and base to print on a small bed with as little supports as possible. Also, the two halves sort of almost close. My prints have been a wee tight and thus I am making the top about 1% or 2% to see if that helps.
Category: DIY