1 / 4
RSCS fan duct for Sapphire Plus 120mm blower
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This fits both the left and the right side of the printer. I oriented it upside down and did not use supports. I…
- Ocena
- 0 / 5
- Polubienia
- 54
- Pobrania
- 259
- Wydruki
- 0
- Wyświetlenia
- 2301
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (73)Powiązane
This fits both the left and the right side of the printer. I oriented it upside down and did not use supports. I printed it in PLA and had some minor warping off the bed. I used a brim and glue stick and it held well enough to finish.
Category: 3D Printer Parts