Wind turbine for nema 17 stepper motor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here is a good use for a stepper motor that would otherwise sit around and collect dust. This is a work in progress…
- Ocena
- 5 / 5
- Polubienia
- 50
- Pobrania
- 654
- Wydruki
- 3
- Wyświetlenia
- 2752
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
Here is a good use for a stepper motor that would otherwise sit around and collect dust. This is a work in progress and the results so far look promising. I wanted a design that was simple and that didn't require any hardware. No screws or bearings needed! The cone threads onto the hub and clamps down tightly on the blades. I am also planning to make a mount and swivel for the motor when I get time and add it on here.
I designed the blades to print individually from the hub and print standing vertically, which requires a build height of 340mm. See pic for suggested build plate setup.
The cone needs support.
Category: Mechanical Toys