Rubber Band holder for Braces
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A convenient, organized solution to store your Rubber Bands and their tools! This dome is more than big enough for all…
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 69
- Wydruki
- 1
- Wyświetlenia
- 646
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A convenient, organized solution to store your Rubber Bands and their tools!
This dome is more than big enough for all of your rubber bands. I loaded 200 in and you can see there's still plenty of room for more!
Print Settings
Printer:
Creality Ender 3 V2
Rafts:
No
Supports:
No
Resolution:
0.28mm
Infill:
8%
Filament:
HatchBox PLA
Black and White
Notes:
Using an infill of less than 8% for the base may not properly support the bottom of the circular dome.
Grid infill is recommended
Estimated Print Time
Base: 6 - 7 Hours
Lid: 2 - 2.5 Hours
Total: 9 - 9.5 Hours
What gave me the idea
Problem
The rubber bands for my braces come in tiny plastic bags. The bands get stuck in the corners and they're hard to dig into to grab the bands. Once i've finally grabbed one, I typically accidentally also grab about 2-3 more, unintentionally, meaning I have to reach my hands back in that tiny bag again to put it back, hopefully without losing the one I wanted in the first place.
Solution
With this model, all the bands will neatly fall to the center, without any corners to reach deep into. If you accidentally grab more than you intended, you can easily drop the remaining bands back in the dome without needing to put them back in a small bag. In addition, you now have an organized way to store your tool(s) as well!
Category: Bathroom