1 / 4
Makita Trim Router Spindle Upgrade for 3018 CNC — zdjęcie 1
1 / 4

Makita Trim Router Spindle Upgrade for 3018 CNC

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Resized and upgraded X and Z Gantry for a standard 3018 CNC machine in order to accept a much larger than stock spindle.

Ocena
5 / 5
Polubienia
71
Pobrania
559
Wydruki
2
Wyświetlenia
3763
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Designed specifically for the "Makita RT0701C 1‑1/4 HP* Compact Router"

Spindle holder is designed to work with stock lead screws, linear rods and bearings as well as anti-backlash nuts. In order to use the upgraded Z-Gantry, new lead screws and rods are required. Sized are listed below

Upgraded Z-Gantry adds approximately 20mm of extra Z height while being more rigid than the factory setup. 

I recommend upgrading to 4 start lead screws and nut/flanges for less play, as well as new higher quality linear bearings.

Required parts:

  • 2x 8mm Linear rods (120mm length)
  • 1x T8 4 Start Lead Screw (100mm length)
  • 2x 4 Start Lead screw flange nuts
  • Factory/upgraded bearings  
  • 2x M4x20 Screws and Nuts

Recommended print settings:

  • Print with PETG for best heat resistance as the spindle can get hot enough to warp PLA. That being said, I have gotten away with using PLA so far.
  • 4 Walls - this gives you wiggle room to sand the press fit bearing areas and make sure that the linear bearings are snug. Also prevents the part from splitting due to pressure from the bearings (I had multiple splits with 2 walls)
  • 40-60% infill - Likely overkill, YMMV

I have included an exploded view of an older revision for extra clarity, only difference is that part #3 has since been replaced with a screw in style flange instead of a threaded insert.

Future plans include incorporating a dust shield to protect Z bearings and rails as well as a more rigid mounting setup for the spindle. I would love to see remixes and improvements! STEP files are available for download as well.

Tagi