2040 Extrusion Tablet Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tablet holder for use with 2040 extrusion.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 1325
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Tablet mount offset to one side, intended for 2040 extrusion. This was designed for a tablet approx. 239 mm in length. I have included two versions:
A split version that allows for printing in parts and assembly with epoxy and screws. That's the version I used in my images and has been holding strong for about 8 months.
A one-piece version for faster setup, but more difficult to print.
The last component is the upper mounting clip. I left it a looser fit to the tablet and padded it with a small foam tab to prevent scratching the tablet itself.
All parts when mounted are meant to be used with T-nuts. The tolerances are tight on the extrusion, so I did not need to use them. This will need to be slid on the extrusion from one end, since it does not clip over the face.
I use this on an Ender 5 Plus as a terminal for Octoprint at the machine.
I also included a STEP file of the split version to allow editing sizes for other devices.