PRUSA Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remake from Mike's model to add a bolt & close holes
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 141
- Wydruki
- 5
- Wyświetlenia
- 2969
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I created this remix from Mike's excellent model, after having printed the first set of parts. This was done to add additional nut & bolt holes to help keep the two parts hold together (I suspect they were a bit warped) and closing the holes to make it simpler.
This may use a bit more filament (but not much) but takes about the same time to print (if I remember correctly).
You can see in the photos that I kept Mike's, and that the two parts hold together quite well in fact. But it was a great introductory exercise into FreeCAD.
The filament guide shown in the pictures is here.