Artillery Genius Bed Cable Strain Relief - Updated/Re-aligned
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The previous version was mis-aligned (at least to my Artillery Genius), by about 3-4mm. I re-created it from scratch…
- Ocena
- 4,5 / 5
- Polubienia
- 4
- Pobrania
- 50
- Wydruki
- 2
- Wyświetlenia
- 357
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
The previous version was mis-aligned (at least to my Artillery Genius), by about 3-4mm. I re-created it from scratch in CAD and gave it a new angle to better support the cable. The crown height was reduced such that the zip ties can properly hold it as well. Finally it was optimized for faster printing, logo removed, et al.
Instructions:
Raise the Z axis up out of the way, disconnect power to the printer.
Remove the back-right bed leveling wheel from under the heated bed.
Slide the part onto the frame and re-install the wheel.
Installing this WILL raise the bed in that quadrant, you will need to re-level the bed, and be careful that the hotend does not hit the bed before it is adjusted.
Print Settings
Printer:
Artillery Genius
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
10%
Filament:
Generic PLA
Grey
Category: 3D Printer Parts