1 / 1
Calibration Square - Three Layers — zdjęcie 1

Calibration Square - Three Layers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is designed to print THREE layers - bottom, infill, and top.

Ocena
0 / 5
Polubienia
0
Pobrania
29
Wydruki
0
Wyświetlenia
191
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Test Models
Licencja
Creative Commons — Public Domain

This is designed to print THREE layers - bottom, infill, and top.

Often times you can have what appears to be a perfectly calibrated first layer, only to discover the 2nd layer has issues sticking to the first (like forming gills). This is usually due to over-squishing layer 1, thereby causing too large of a gap between layers 2 and 1. The resulting gap between these layers causes layer 2 to act oddly. Sometimes subsequent layers recover, sometimes they don't. By building in layers 2 and 3 into a calibration, we can fix the issue before moving on to a "real" print.

1. Get layer 1 to stick by moving the nozzle closer.
2. Observe layer 2. If it peels away or forms a sort of gill, your nozzle is too close and a vertical gap results between layer 1 and where the printer starts layer 2.
3. Observe layer 3. If you had to accept minimal peeling/gills to keep layer 1 sticking, ensure layer 3 at least squishes them back down.


Relevant Settings
Note: Currently set to calibrate a .25 nozzle. To adjust, set to 3x the layer height you are after, then adjust the settings below.
--------------------------------------

Fill Density: 100%
Layer Height: 0.2mm
First Layer Height: 0.2mm
Perimeters: 1
Solid Layers: 1
Minimum Shell Thickness: 0.2mm

 

Photo:
In the photo you can see where I started with a printer that was set with a nozzle offset that was too low. It is progressively adjusted to reduce the “gills" effect on prints from left to right.