Lens Cap Holder for Canon/Nikon multisize, low-profile, strong grip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Please request sizes for your personal need! Up to 4 sizes in one holder is suitable. 3 is better for a low profile.…
- Ocena
- 5 / 5
- Polubienia
- 41
- Pobrania
- 193
- Wydruki
- 3
- Wyświetlenia
- 848
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
Please request sizes for your personal need! Up to 4 sizes in one holder is suitable. 3 is better for a low profile.
The nominal lens diameter is to be found on the inside of the cap. The actual hole diameter of the holder is like the griping diameter on the lens 0.5 to 1mm smaller than this number to fit the cap.
Print in high quality 100% infill PETG, layer height 0.2mm for a tough and lasting experience. PLA not recommended for this low profile design because of its low impact strength.
All the multi-size lenscap holders I could fing and print were utter crap, either they would not hold the cap secure or they were bulky and impractical.
So I decided to design my own and am very glad I did. It works great for me and I welcome any feedback how it works for you!
Please leave me a comment for the hole sizes you need, I will upload any rasonable request. I think 4 sizes is the maximum usefull number of lens cap fits for one holder. 3 is decent in size.
The upload features holder diameters for following Canon Lens sizes:
49mm (e.g. EF 50mm 1:1.8 STM, best fit diameter 48.5mm)
52mm (fit diameter 51.5mm)
58mm (e.g. EF 100mm 1:2.8 USM, best fit diameter 57 to 57.5mm)
67mm (e.g. RF 24-105mm F 4-7.1 STM, best fit diameter 67.5mm)
77mm (e.g. RF 70-200mm L 4 USM, best fit diameter 76.5mm)
95mm (fit diameter 94.5mm)
But also works for Nikon lenses with the same lens size. (Other brands not tested.)
Category: Camera