Fellow Atmos Label Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A slim holder that allows coffee bag labels to be attached to a Fellow Atmos coffee storage container.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 57
- Wydruki
- 1
- Wyświetlenia
- 614
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This is a simple holder meant to hold a label on the exterior of a Fellow Atmos coffee container. I found that at times I would lose track of which beans I had in which container, especially if I ended up being away for a bit without using them, so I threw together this simple design.
It is designed to fit on the 0.7 liter version of the Atmos series. It will of course also fit on the larger 1.2 liter version, but is too tall for the 0.4 liter version. I only have the 0.7 liter version so I don't have the dimensions needed to redesign it for those. I only have the metal bodies so I have not tested it with the glass version, but I believe it should work.
The label area is roughly 95 x 75 mm, but I just trim them until they fit without any precise measuring process. They are designed to be attached with adhesive; I just used some rubber cement to make them removable if needed.
Printing tips
Print the model standing up with supports everywhere, but make sure you use “snug” supports only. The normal PrusaSlicer support algorithm will generate supports inside the label area which will be virtually impossible to remove.
Update: With PrusaSlicer now offering organic supports, those are strongly recommended as they significantly reduce the cleanup needs.