Wall Mount for Edifier G2000 Speakers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for Edifier G2000 Speakers
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 156
- Wydruki
- 0
- Wyświetlenia
- 1499
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to mount the Edifier G2000 speakers I use in my hobby room on the wall. Unfortunately they are naturally titled up, so just printing straight shelves would have directed the sound onto the ceiling, not into the room.
Therefore I designed this stand to mount the speakers on the wall tilted down slightly. The mounting holes are designed for 4mm diameter screws, which I anchor to the wall with 6mm anchors/rawplugs/plugs (not sure of the correct word ;))
The files are oriented in a way which I found best for printing to not have the main forces along the layer lines, but perpendicular which is much stronger. There is a cutout for cables, but no management solution as I did not care about it.
I'm printing out of ASA but am pretty sure PLA should also work. I would not recommend PETG as I'd expect it to sag with time.
I printed with 4 walls, 5 top/bottom layers and 40% infill. Less might work, but I did not want to risk it. I know the overhangs on the sliders are relatively tough, but supports worked well enough for me.
Disclaimer: I'm not responsible if your speakers fall from the wall and get damaged! It works for me, but I don't know your printer, filament or walls! I'm not aligned with Edifier in any way