Sexy Tentacle Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tentacle hook that prints with minimal supports and has recess for a screw.
- Ocena
- 4,75 / 5
- Polubienia
- 158
- Pobrania
- 610
- Wydruki
- 10
- Wyświetlenia
- 3914
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Wife requested a hook, wife did not state the exact nature of the hook, Sexy Tentacle Hook was born.
This is a remix of the Magnetic tentacle hook but reworked in Meshmixer so it prints with minimal support.
I sliced using Cura with the model at 45 degrees on the build plate. This was to help with areas where bridging was needed. I used supports touching build plate only, then added support blockers so that the only part actually getting support was the arch under the tentacle.
I was going for maximum tentacle sexiness and didn't need the hook to carry much weight so printed at .12mm layer height, 3 walls and lightning infill (Ender 3 with .4mm noozle).
Credit for the origional design goes to Bidumadio
https://www.thingiverse.com/thing:4822459
and John U
https://www.printables.com/model/87246-magnetic-tentacle-hook