ML120 - 120mm Quad frame for brushed 1020 motors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fully enclosed 120mm FPV frame for brushed quadcopter. I abandoned this model some time ago. Might be useful to someone.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 131
- Wydruki
- 0
- Wyświetlenia
- 697
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I abandoned this model some time ago but I am leaving it here, if you want to continue.
Fully enclosed 120mm FPV frame for brushed quadcopter. Designed for specific hardware, that will be used in my quad. Battery is mounted from bottom using 5mm wide rubber band. Lid can be removed. Opening mechanism is not yet fully sorted out, one can still use cable ties to hold lid in place.
Weight is now a bit higher, frame is around 15g and lid around 8g.
Hardware
This is hardware that will be used in my quad:
- Motors - 1020 brushed quadcopter motors
- Props - Some 74mm props for 1.2mm shaft
- Flight Controller - F3 EVO Brushed 2.0
- Camera - Eachine US65 with VTX
- Battery - LiPo 3S 500mAh
- Receiver - something smaller... (I am using some FrSky D8 receiver)
- RGB - some tiny 4 TGB leds strip (marked aurora rc)
- cable tie to reinforce vtx antenna
Future Plans
- motor cable brackets
- battery connector holder
- crash tests and reinforcement
- receiver antenna cable tie mount
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
designed with .4 nozzle and .2 layer in mind
Infill:
1mm top and bottom, 1.2mm perimeters, some basic 15% infill
Filament: Any PLA
Notes:
print UPSIDE DOWN.
printed, not yet tested, this is still work in progress...
Category: R/C Vehicles