1 / 8
Safariland to Amomax Holster Adaptor — zdjęcie 1
1 / 8

Safariland to Amomax Holster Adaptor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows you to use Amomax rotary-style holsters on Safariland QLS plates or just on the UBL

Ocena
5 / 5
Polubienia
32
Pobrania
441
Wydruki
1
Wyświetlenia
2107
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Update:

Updated the model and re-did the interface for the Amomax side. Slightly thickened the whole thing and generally made it a bit nicer.

 

Printing Instructions

No support needed in the nut hole on the bottom. For settings I would reccomend using a good amount of walls - I've used four. And .2 layer height so there is enough detail for the top interface.  

 

Hardware

For either version you will need 3 M6 nuts and bolts to hold it to the QLS plate or UBL. I for me the perfect length is M6x16 for the 3 bolts and I'm using 3 nyloc nuts. But this will depend on the depth of the counterbores on your QLS plate.

 

SHM V10

Standard version, you can use a 10mm m6 cap head screw. (Should petrude out the front into the holster about 4.5mm so screw may need to be shortened slightly.)

 

SHM V10 Countersunk

Countersunk version, you can use a 14mm countersunk m6 screw (should petrude about 4mm so screw may need to be shortened slightly if it can't be fully tightened). This should be stronger than the standard version as there is much more plastic along the layers.

 

PA12 Nylon

I had the countersunk version printed at JLCpcb for less than $10 posted and it should be much stronger than it ever really should need.

 

 

Tagi