Stackable Keycap Storage Trays (Vase Mode)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement tray to keep your extra GMK or other cherry keycaps in. Prints in Vase/Spiralize mode for quick printing.
- Ocena
- 3,833 / 5
- Polubienia
- 123
- Pobrania
- 576
- Wydruki
- 8
- Wyświetlenia
- 3012
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
GMK sends their keycaps trays meant for disposal. Some of us want our collections protected. So, I designed a simple tray to replace the potato starch GMK trays.
The lid needs to be printed normally, but is still a low amount of filament.
The trays need to be printed in Vase or Spiralize mode. You definitely want to set your line width to .8 in order to make the walls strong enough. (it is ok to do this on a .4 nozzle, see video below for details.)
Probably bump your Hot End temp up a bit I went up 10 degrees, but this really depends on your extruder.
I recommend a brim to keep the bottom flat.
Set the bottom and top layers to 2x your line width so you have a nice strong base.
If you have questions about the vase mode settings Lost In Tech covered it quite well.