1 / 8
Reclaimed 10" Tablet Screen Monitor — zdjęcie 1
1 / 8

Reclaimed 10" Tablet Screen Monitor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Use a reclaimed tablet lcd to create a small monitor.

Ocena
0 / 5
Polubienia
0
Pobrania
11
Wydruki
0
Wyświetlenia
247
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Use a reclaimed tablet lcd to create a small monitor.

Print Settings

Printer Brand:

Prusa

Printer:

Mk2.5s

Rafts:

No

Supports:

Yes

Resolution:

.2mm

Infill:

20%

Filament: Inland PLA Black / Natural


Notes:

I had a bricked Asus 10.1" tablet with a good screen. I searched eBay for a generic hdmi lcd controller board, I've done this with laptop and other reclaimed lcd panels. The model number on the controller is generally m.nt68676.2 or m.nt68676.2a. If you use the panel's part number in the search you'll find them all over eBay. Generally about $30usd. I used 123d Design, I know fusion 360 is free and better, but I know how to work with 123d Design, and I'm old and cranky so drop it! ;)

The Base uses m3 brass standoffs and hex nuts to mount the controller pcb, Then more standoffs to mount the switch pcb for controlling the screen. there is a pillar with a captive square m3 nut as well as a small bridge to secure the button pcb to the other standoff. There are a total of 6 stand offs in the controller base, All the hardware in the base it m3, the lid uses m2.5 screws directly into the bezel, so be careful not to over tighten!

I added the Jinx.com graphic, because I like it, and with natural filiament it glows nicely from the lcd backlight, I've included a lid with no graphic cutout as well. The graphic cut out and the corresponding parts in the lid are a tight fit, but I still used super glue to secure everything well.

All the hinge, cable strain relief, and button parts are included in the MISC Parts file, so you don't have to print multiples of anything. I'll list the hardware required below.

Hardware

10mm M2.5 screw = 7

6mm M3 screw = 2

8mm M3 screw = 2

20mm M3 screw = 2

M3 Hex Nut = 6

5mm M3 Brass Standoff = 2

10mm M3 Brass Standoff = 2

15mm M3 Brass Standoff = 2

UPDATE

Added new lid back with the logo from my favorite Podcasters/Youtubers GenXGrownups!

Check them out www.genxgrownup.com

Category: Tablet

Tagi