Inside Swing out Spool Holder for Corecepttion, Elf & SapphirePro

Update 2 Dec 2020:

1. A more robust locking clip MK4 added to improve the locking rigidity of the swing out bracket and has a two (2) degree angle out for a bit more clearance from the build plate.
2. A new pneumatic fitting bracket with a 45 degree angle to reduce the bend of the feed tubing when inside an enclosure.

---

This spool holder mounts to vertical 2020 Aluminum extrusion and holds the spool inside the boundaries of the frame. This is handy if using the O.E.M, enclosure from SainSmart, Creality or other Maker designs.

Features include:

1. 608ZZ or 608RS roller bearing spool center Axle with slip joint design inspired by https://www.thingiverse.com/thing:3020026.
2. Rolling axle holder with raised end to inhibit the spool from coming in contact with the heated build surface.
3. Hinged spool bracket using UNC #2-56 X 1" screws, nuts and washers or M2.5 similar hardware.
4. Locking pin provision to hold the spool inside or a 90 degrees out to easily remove prints or change filament.
5. A new compact one piece design PC4-10 or PC4-01 fitting for the feed tubing up to the extruder.

SainSmart Coreception-300 3D Printer Enclosure - https://bit.ly/3kUbbbS

Creality 3D PRINTER ENCLOSURE - https://bit.ly/3kV0J3J

Print Settings

Printer Brand:

XYZprinting

Printer:

Rafts:

No

Supports:

Resolution:

0.20-0.30

Infill:

Filament: Any; printed using Sunlu & IPSG ABS ABS, PLA+ (Pro) or PETG Any

Category: 3D Printer Accessories