1 / 3
Two Motor Z Gantry - Big Plans Printer System
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two Z Motor Gantry and Bed Platform
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 783
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (19)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (7)Powiązane
These models are part of the Big Plans 3D Printer System: https://lilmikey.com/printersystem/ZGantry.html
These models comprise a two-Z-motor gantry for many configurations of cube-style printers using 8mm smooth and threaded rods.
- Smooth Rod Guide Top - mounts to the underside of the upper frame extrusion (2020). Holds an 8mm smooth rod clamp.
- Smooth Rod Guide Top -40mm - mounts to the underside of the upper frame extrusion (2040). Holds an 8mm smooth rod clamp.
- Smooth Rod Bearing Mount - mounts to the bed platform and takes an LM8UU bearing. Use for belted Z motors.
- Smooth Rod Bearing Mount - Motor Mounted Rod - mounts to the bed platform and takes an LM8UU bearing. Use for shaft mounted Z motors.
- Smooth Rod Guide Base - mounts to the lower frame extrusion and holds an 8mm smooth rod clamp.
- Threaded Rod Nut Mount - mounts to the bed platform and takes an 8mm threaded rod nut.
- Threaded Rod Pillow Top - mounts to the underside of the upper frame extrusion (2020). Use for belted Z motors.
- Threaded Rod Pillow Top - 40mm - mounts to the underside of the upper frame extrusion (2040). Use for belted Z motors.
- Threaded Rod Pillow Top - Motor Mounted Rod - mounts to the underside of the upper frame extrusion (2020). Use for shaft-mounted Z motors.
- Threaded Rod Pillow Top - Motor Mounted Rod - 40mm - mounts to the underside of the upper frame extrusion (2040). Use for shaft-mounted Z motors.
- Threaded Rod Pillow Base - mounts to the lower frame extrusion and holds a pillow bearing for an 8mm threaded rod. (Note, if using a shaft-mounted threaded rod you will not need this part - only the motor mounts.
- 20mm T Joint - used for construction of build platform.
- 2002 90 degree - used for construction of build platform
- Bed Plate Mount Offset - 2020 mount that takes m3 bed leveling screws - offset to one side.
- Bed Support Platform - 2020 mount that takes m3 bed leveling screws.
- Z Motor Mount - Basic 2020 mount for NEMA17 stepper with an offset tab for extra holding power. Can be used for belted or shaft mounted threaded rods.
- Z Motor Mount untabbed - Basic 2020 mount for NEMA17 stepper. Can be used for belted or shaft mounted threaded rods.
- Bed Leveling Knob - M3/M4 - Large thumb-knobs for adjusting bed leveling screws. Compatible with M3 or M4 nut.