Huawei Honor 6X and Asus Zenwatch2 Charging Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Charging stand for the Huawei Honor 6X and an Asus Zenwatch2. This is designed for the cord that came with my watch.…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 143
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
Charging stand for the Huawei Honor 6X and an Asus Zenwatch2. This is designed for the cord that came with my watch. You may have to modify the charging cord opening based on your cord(s). The phone cord that this is modeld for can be purchased here: https://www.amazon.com/gp/product/B01M0LK2SK/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1
The phone opening is designed to accept the phone in a case. The case that this is designed for can be purchased here: https://www.amazon.com/gp/product/B01MG92TCO/ref=oh_aui_detailpage_o02_s00?ie=UTF8&psc=1
If you use a different case or cord, there's a good chance you'll have to modify the stand.
Feed the phone cord through the hoop at the rear, then down through the hole in the bottom, through the groove, then up into the charger seat. For the watch cord, feed it through the hoop in the back, through the hole in the side, through the hole in the face, then into the charger seat. Friction should keep them in place for the most part, but i like to use a little hot glue to keep them in place until I need to remove them.
Use supports everywhere, to support all of the various openings. I printed mine at 20% infill.
A bonus with this design is that the front firing speaker hole seems to provide an increase in dB for the speaker. Makes it great for using your phone as your alarm.
Print Settings
Rafts:
Doesn't Matter
Supports:
Yes
Infill:
20
Category: Mobile Phone