Coffee Measure with Long Handle

Please find my newer revised design which makes supports much easier to remove.  It is named "Long Handle Coffee Measure with easily removed supports"

I printed in PETG but PLA should work fine.  The part has a 45 degree chamfer on the base which does not need supports but the handle does need them.  I have described how I set up the supports using the Prusa slicer below.   I modified the default settings (some are advanced or expert setings) as follows:

     Layer height 0.20 mm  or smaller

    7 top and 7 bottom layers to make the bottom of the part solid

    5 perimeters

    15% rectangular infill

    overhang threshold = 40 degrees to avoid unneeded supports

    pattern angle 90 (with part extending left to right) see picture

    top interface layers = 1 (light)  for easier removal of supports

    interface pattern spacing 0.4 mm  for easier removal of supports

    I oriented the part so that the support interface layers are in line with the handle as shown in the picture.  Using this support arrangement a putty knife can be used to scrape off the interface layer since it is perpendicular to the part layer resting on it.   The extra interfacing pattern spacing makes it easy for the scraper to engage the interface layer.