Anbernic RG351P Slim case "Plain"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A slim, tough, stylish hard case for your RG351P
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 91
- Wydruki
- 1
- Wyświetlenia
- 876
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A very slim and stylish Case to protect you RG351P. ( still waiting for my RG351M to test if it fits as well, it should but cannot say for sure until I was able to testfit)
It comes in two versions, with and without an USB pass through.
Your screen is perfectly protected once the lid is closed as it locks your device in place with a 3 mm gap in between the inside of the case wall and the Screen.
Easy access to charge your device while it sits in its case thanks to the USB passthrough.
All you need is 2 round magnets ( 6mm in diameter and 3mm thickness) glued into the respective holes of the case.
Two short strips of 1,75mm filament for the hinges. Heat the ends up just a little and press it against both ends of each hinge to fix the "hinge bolt" into position.
Also use some superglue to glue the magnets in, as the magnetic force is quite strong and can overcome the " friction fit" pulling a magnet out of its base.
You can easily open the lid on the magnet lock base overhang on the left and right side with your thumbnail.
If you want to protect your device even more use two small rubber sponge pieces on the bottom and lid of the case ( check the pictures to see what I mean)