Anbernic Original RG350 Gamepad holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A nice comfy grip for your original RG350
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 119
- Wydruki
- 1
- Wyświetlenia
- 894
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Finally done, a nice comfortable grip for your original RG350.
The base for the design was a very ruff 3D scan of a Xbox 360 controller I found online.
You need some sponge rubber or thin felt for the sides, as this Gamepad secures your device with friction, it works very well! Just slide it in from the top. ( sponge rubber grips better then felt)
I am especially very proud of the sound enhancement that works quite good.
its a cavity in both grip sides which produces a much richer sound and even some sort of bass....sorta ;)
the Game pad stands on its own with the RG350 attached for nice display options.
Depending on the print quality I would recommend to also glue a thin layer of soft and sturdy material on the front facing area where the RG350 slides in. ( to protect the backside of your RG350) or you print Version 5 "Softback" and stick some felt pads inside the 4 dents at the front surface.
4 versions are available:
1.) No logos at all.
2.)Anbernic Logo on the back, standing outwards
3.)Anbernic Logo on the back, standing outwards+ my Maker Logo on the front Cut inside.
4.) Anbernic Logo on the Back Cut inside + Felt inlays to protect the back of your RG350 from scratches + an even tighter fit for maximum safety.