Jellybean switch mount for wheelchair headrest
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a headrest mount for an Ablenet Jellybean switch, which is 84mm in diameter with a ~4mm lip.
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 169
- Wydruki
- 1
- Wyświetlenia
- 1066
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution
This is a headrest mount for an Ablenet Jellybean switch, which is 84mm in diameter with a ~4mm lip. This clip can open up to 45mm wide.
If you make this, it would be awesome to see pics of your makes!
Print instructions
I've printed this on a Prusa MK3S at 0.15mm layer heights without issue. Supports are required, but I did use support blockers for the big arching curve since the overhangs there aren't bad.
Also, there is a small chamfer on the bottom (0.4mm @ 45 degrees) that should help minimize the "elephants foot" effect.