Raspberry Pi 3B+ Octoprint Case with Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Note: This case is designed for the Raspi 3b+ if you need a case for the 4b it is linked here. This case is designed…
- Ocena
- 4,778 / 5
- Polubienia
- 77
- Pobrania
- 548
- Wydruki
- 14
- Wyświetlenia
- 2537
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Note: This case is designed for the Raspi 3b+ if you need a case for the 4b it is linked here.
This case is designed arround the Raspberry Pi 3b+ and provides for mounting a 30x30x7 mm 5V fan.
Features
*Case cover with OctoPrint Logo
- Access to GPIO pins
- Access to camera ribbon cable connector
- Access to SD card
- MicroUSB power connector access
- HDMI port access
- Access to 3.5mm composite video/audio connector
- LAN port access
- USB port access
- Ability of monitoring status LED's.
Designed to fit
- 30 x 30 x 7 mm fan
- M 2.5 screw kit
*OctoPrint and the OctoPrint logo are registered trademarks* octoprint.org
Print Settings
Printer:
HyperCube Evolution
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
30%
Filament:
3D Solutech PLA
What ever color you chose.
Notes:
The case is designed to be printed with a .4 mm nozzle
I found that printing the status viewing lens is best with 1 perimeter and 100% fill. To color the raised text, I used a black magic marker.Note The status viewing lens can be printed with other than clear or translucent material. The darker the color the less illumination will be viewable through the lens.
Post-Printing
Built in support material for the screw holes needs to be removed. I used an X-Acto knife to remove it but a drill bit works too.
The case screws utilize self threading into the case standoffs. Pre-threading prior to assembly is advised.
Needed hardware:
- Case screws
- 4 M2.5 x 8 mm screws
- Fan Screws (Either the hardware supplied with the fan or the following)
- 4 M2.5 x 12 mm screws
- 4 M2.5 nuts
- Mounting hardware
- 2 M5 x 10 mm screws for 3030 extrusion mounting.
- 2 M5 hammerhead nuts
- 30 x 30 x 7 mm fan
Additional Notes:
*When assembling the case to the Raspberry Pi verify that the fan screws clear the CPU heatsinks. (Screws supplied with the fan are usually longer than 12 mm.)
- To insure that the nuts do not come loose, place a small drop of glue to hold then in place on the screws.
The above is from the vendor's install directions to Connect the fan to GPIO pins of Raspberry Pi
Category: 3D Printer Accessories