Sony Spresense case with LTE extension board and camera
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for a Sony Spresense development board with camera board, mounted on an LTE extension board
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 31
- Wydruki
- 1
- Wyświetlenia
- 321
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
The enclosure is designed so that everything press fits, with no screws required. A 25mm (1 inch) M5 bolt and nut is required to connect the clamp to the enclosure.
The designs can be edited in OpenSCAD.
Print Settings
Printed on Prusa i3 MK3:
- Filament: PETG
- 0.20mm SPEED
- Infill: 20%
- Supports: None
Takes about 2 hours to print the enclosure and 30 minutes for the clamp.
Credits
The enclosure uses the YAPP (Yet Another Parametric Projectbox) generator, which is included in the lib folder and licensed under the MIT license. The clamp is based on the Click & Clamp by andrelf, which is licensed under the Creative Commons Public Domain Dedication license.