CY7C68013A box for logic analyzer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the low profile version of https://www.thingiverse.com/thing:2153437 by @bobtidey. I created a cap…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 304
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a remix of the low profile version of https://www.thingiverse.com/thing:2153437 by @bobtidey. I created a cap for the power button, extended the lid 1mm to center it better over the I/O pins and added a little hole over the reset switch that allows resetting the board with a toothpick or similar item.
The lid is oriented upside down compared to the original version. On a printer with a glass build plate, the bottom side is usually smoother and therefore the top of the lid gets printed in a better quality if printed this way. The overhangs on the sides are 45° and can be printed without supports.
I added a SVG & PNG version of a lable that you can put on the lid.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
20%
Filament: DasFilament PLA Black
Notes:
I printed the power switch cap at 0.1 mm resolution but 0.2 mm should work fine too.
The corners of the lid that face inside the box needed a little bit of sanding to round them a bit. The power switch cap is a tight fit. Press it down and it should just snap onto the switch.
Category: Electronics