DJO Mini 3 Pro Charging/Cooling Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a charging and cooling base for a DJI Mini 3 Pro drone.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 1167
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a charging and cooling base for a DJI Mini 3 Pro drone. I highly recommend printing in a “crystal” PLA filament so you can see the status light of the drone charging through =)
The Mini 3 pro has no internal fan and so it uses the drones own movement to push air in through the front grille behind the camera/gimbal and back over the cpu and heat sink, and out the back vent holes.
Its likely that a fan mounted on this cooler should suck air out of the drone as a result, though its not clear to me how much difference that would make.
- It has a spot for a 92mm fan or 80 mm (I am using Noctua NF-A9) to be bolted onto the cooler,
- a hole for a magnetic charging cable (do not glue the end of the cable, rather let it be flexible so it can move to where the magnetic piece is on the drone)
- a hole for a micro switch to turn on the fan when the drone is put into the base.
Fan: https://www.amazon.com/gp/product/B00NEMG9K6
Cable: https://www.amazon.com/gp/product/B09F6BGRV6
Switch: https://www.amazon.com/gp/product/B075RDL2RG
I actually print this without supports to save time and filament - the first overhangs look like garbage but there internal.