Banana Split Boat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bowl for your banana split sunday!
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 417
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
A bowl for your banana split! This is a pretty good size bowl so you can go nuts building the biggest sunday possible. I fix on the MK3 build plate left and right, but it does go right to the edge. It's a very easy print.
I used PLA to print these, they were intended for single use, but with warm water and soap you should be able to clean these up for a second use. As always, be careful with 3D prints and food.
I printed these bowl with enough tops and bottoms so there would be no infill. (I just set them to around 12) Also with the perimeters. I set them so it would be solid. This was to avoid leaks and the bowl is water tight and pretty heavy. Takes about 8 hours to print.