(FrankenQuest/DAS) Universal Powebank Holder for DAS

Greetings, I designed a universal power bank holder for the DAS based on a reference model (lost the link will updated if I ever find it), mainly to use with my FrankenQuest, it has been a great addition. I used a commercial solution before but I lay down a lot in VR and it was impossible with the old placement of my PB, and I've been happy with the weight distribution (been using it for over a year now re-upload to this platform) using it as far back as it goes.

Printing

This model requires no support that was the main goal. Align the flat base to the print bed. (I war pretty noobish when I first made this).

A .20mm 40% fill should do fine, higher resolution helps with the adapter not scratching the surface.

I used 104% scaling for my model, I would advise to go up scaling rather than down scaling because the DAS naturally widens as you go deeper.

Requirements

• 3x 1.2cm by 20cm Velcros.
• Rubber feet or double sided velcro pads.

Sadly for this to be universal you need velcros and a way to make the surface grippy.

For Velcros I used 1.2 cm by 20 cm you need 2 to hold the power bank and 1 to hold the excess cable. I recommend this ones: https://tinyurl.com/jdrd5svs

To make the surface grip better and prevent sliding I used furniture rubber feet similar to this one: https://tinyurl.com/6m5jvcek . But on second though you can use double sided velcro pads to achieve the same.

Optional

To protect your DAS surface you can add 3M electrical tape to the back of the adapter where the adapter couples with the DAS, this will ensure better grip and less scratches on your device.

PowerBanks I have used it with

• ADATA PT100 https://tinyurl.com/vyn9f6nm
• RAVPOWER 15 000mAh (No longer listed or available its the one in the previews.)

Hopefully you enjoy using this adapter!.