Filament Holder for 2,3 Kg / 5 lbs filament spools
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament Halterung für 2,3 Kg Filament Spulen mit Standard Gewinde
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 406
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Diese Halterung lässt sich mit den Standard schrauben eines Druckers befestigen. Die Halterung ist in 100 % Größe großgenug um eine Filament Spule von einem Gewicht von 2,3 KG halten. Ist, wie bei mir, die Oberfläche des Druckers, auf dem die Spule befestigt wird, nur ein dünnes Blech, kann es sein, dass sich die Halterung ein wenig nach rechts biegt. Dadurch kann die Spule auf Dauer von der Halterung rollen. Es empfiehlt sich einfach ein Kabelbinder an der gewünschten stelle zu befestigen und die Rolle bewegt sich nicht mehr runter.
---
This holder can be attached with the standard screws of a printer. The bracket is 100% large enough to hold a filament spool weighing 5 lbs. If, as in my case, the surface of the printer to which the spool is attached is only a thin sheet of metal, it is possible that the holder bends a little to the right. This can cause the spool to roll off the mount in the long run. It is recommended to simply attach a cable tie at the desired location and the roll will no longer move down.