24mm table leg insert for M10 adjustable foot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 24mm insert for a table leg. It holds an M10 nut, so that an M10 adjustable foot can be screwed into it.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 591
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
I have a garden table with a frame made of 3mm steel square tubing with an inner size slightly over 24mm and an outer size of ~31mm. This frame has one shorter leg, that should have an adjustable foot attached. It is used to stabilise the table on uneven ground.
The previous insert I made for it had broken and this one is made to be a lot stronger.
Bill of materials
- The print of this model
- 1×M10 adjustable foot
- 1×M10 hex nut
Printing
Print the model lying on it's “back” with the insert hole at the top. This is essential, as it means that the main force the table puts on the print along the vertical axis, will be along a horizontal print-axis. The vertical print axis has limited tensile strength in this type of 3d printing.
I printed it in black ABS with 25% infill.
Installation
- Put the M10 nut in the insert hole
- Align the insert with the table leg, and gently hammer it in.
- Screw in the adjustable foot
- Adjust foot until the table is stabilised