Sliding LACK GoPro-like camera mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A camera mount that clamps around the leg of a LACK table and can be easily adjusted vertically by…
- Ocena
- 5 / 5
- Polubienia
- 63
- Pobrania
- 243
- Wydruki
- 5
- Wyświetlenia
- 1634
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
A camera mount that clamps around the leg of a LACK table and can be easily adjusted vertically by loosening/tightening the large screw. Fits GoPro accessories for adjustable camera angles. Can be used on any of the four legs by changing the orientation.
I use it with the Prusa Printer Enclosure V2 where I have a small gap between the acrylic plates and the table legs.
UPDATE: New clamp that can be printed without supports
Print instructions
PLA is to brittle for the clamp because of the thin walls. I printed mine using PETG instead and it holds up fine. For the screw and plate I used PLA, but PETG should also be fine.
If printing from stl, you will need support from the print plate underneath the GoPro-mount. There is a vertical support inside the screw holes. Remove with pliers/knife/small screwdriver after print.