AA Battery Dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a way to not only store my batteries but also make sure that they all get rotated through service. I was…
- Ocena
- 4,75 / 5
- Polubienia
- 53
- Pobrania
- 404
- Wydruki
- 9
- Wyświetlenia
- 2452
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
I needed a way to not only store my batteries but also make sure that they all get rotated through service. I was having one or two batteries at the bottom of my storage case that would not get used and re-charged. This solves the problem for me. I also made a 9 volt version and a AAA version.
Print Settings
Printer:
Artillery X1
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.35
Infill:
15%
Filament:
generic petg
orange
Notes:
I print fast and dirty using .35mm height and 1mm width, it seems to work out quite well, but if you prefer to have prettier prints then you could print it however you would like and it should work out fine. No supports are needed as the little mating "pins" that I have created are built on top of an angled base that doesn't need support.
Category: Organization