Reloading Dillon 750 and 650 toolhead holder / toolhead stand for tool wall
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dillon 750 and 650 toolhead holder for tool wall. This is made for a tool wall with square holes 9x9 and a pitch of 38.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 137
- Wydruki
- 0
- Wyświetlenia
- 1308
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Dillon 750 and 650 toolhead holder for tool wall. The holder can also store all the parts from the dillon caliber conversion kit.
The toolhead holder is made for a tool wall with square holes of 9 mm x 9 mm (0.354") and a pitch of 38 mm (1.496"). The toolhead holder will also fit 10 mm x 10 mm (0.394") holes as long as the pitch is the same.
When mounting the toolhead holder to the tool wall, be cautious of the dies that protrude on the underside! Some clearance, between the table and toolholder, is needed for the dies!
The tool holder is printed standing upright (see last picture) with supports everywhere. It is printed in Prusament PETG Ultramarine Blue Transparent with an infill ratio of 15%.
The tool head pins are printed the same but individually and with a very slow speed so the pins don't get deformed.