Happymodel Larva X Whoop Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Whoop Frame for Happymodel Larva X, works with screws included with drone purchase. Successfully tested but may need…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 512
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Whoop Frame for Happymodel Larva X, works with screws included with drone purchase.
Successfully tested but may need modification.
Note: There are two models, one for Larva's running 3 screw hole motors and one for 4 hole motors. Neither uses all of the screws for mounting because it was a huge pain to swap out.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
.2
Notes:
Use supports with 60 degree overhang for best results. .3mm gap between supports and print will make them easy to remove.
Category: R/C Vehicles