Neopixel Shroud for EVA 3

This is a simple remix of the EVA 3 small shroud with the small addition of a wider chin with a simple opening for a single NeoPixel to light up the hotend.

I was in a need for some light quickly, so theres not a mechanism in place to hold the NeoPixel yet. I simply glued mine in.

I will improve on this when I have some time.

I am using an Adafruit SK6812 NeoPixel 

Below is a sample klipper config to enable the NeoPixel on full time:

[neopixel hotend_rgb]
pin: PA3
#   The pin connected to the neopixel. This parameter must be
#   provided.
#chain_count:
#   The number of Neopixel chips that are "daisy chained" to the
#   provided pin. The default is 1 (which indicates only a single
#   Neopixel is connected to the pin).
color_order: GRBW
#   Set the pixel order required by the LED hardware. Options are GRB,
#   RGB, GRBW, or RGBW. The default is GRB.
#initial_RED: 0.0
#initial_GREEN: 0.0
#initial_BLUE: 0.0
initial_WHITE: 1.0
#   Sets the initial LED color of the Neopixel. Each value should be
#   between 0.0 and 1.0. The WHITE option is only available on RGBW
#   LEDs. The default for each color is 0.