2020 Extrusion X Axis Belt Tensioner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An X Axis Belt tensioner that's easier to use than the stock Creality tensioner
- Ocena
- 5 / 5
- Polubienia
- 110
- Pobrania
- 796
- Wydruki
- 6
- Wyświetlenia
- 4364
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This X axis belt tensioner is far easier to use than the stock Creality tensioner when doing maintenance.
You can use the two stock bearings, M8 x 1.25 x 25 “axle” bolt, and one of the M4 socket head screws and t-nuts. Additionally, it requires an M5 x 0.8 x 25 hex head screw, and M5 x 0.8 x 4 nut or M5 x 0.8 x 10 heat-set insert. There are two mount and knob files depending on which parts you choose to use.
Recommended print orientation in the photos. Use ABS/ASA or at least a PLA+(if not in an enclosure). If your parts cooling is pretty good then you can print with no supports but it will all print fine with support if needed.
Additional required parts. McMaster.com part numbers for reference. You can easily get these in smaller quantities at a hardware store:
M8 x 1.25 x 25 button head screw - 92095A286
M5 x 0.8 x 25 hex head screw - 91287A126
M5 x 0.8 x 4 hex nut - 91828A241 or M5 x 0.8 x 10 heat-set insert - 94459A180
Here is a short assembly guide video -