Thundershot SuperSnub Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ups the ergonomics and style of your Thundershot blaster!
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 515
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
Designed this as a kit to replace the over-long barrel, and tiny grip. Now your pinky isn't left dangling in the wind.
There are also 3 versions of the muzzle, Classic, Tactical, and Stubby. All three work the exact same, so you can just pick whichever one you like most.
Also included is a spring spacer. This is placed behind the spring, and slips over the top of the plunger rod. No need to remove the plunger head pin. This not only adds a bit of extra precompression to the spring (more power), but also reduces the amount the plunger tube can slide, which gives a better seal from the plunger tube to the cylinder.
And now, A hammer mod is also available. This brings the hammer back by quite a bit, making it easier to prime one-handed. It's still a bit more of a reach than a Hammershot, but it's the best I could do without requiring you to cut up the shell.
Printing:
PLA
1-3mm Layer Height
10-15% Infill
2+ perimeters
Everything should simply integrate directly with the Thundershot shell, and the new Grip accepts the original screws from the old Grip.
You MUST print the Spring Spacer at or below 0.2mm layer height, as the tolerances are very low, for where the spacer needs to fit.