Holder for small hair dryer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple holder made for a hair dryer (diameter ca 6 cm). The holder can be attached to a wall with double sided tape.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 110
- Wydruki
- 0
- Wyświetlenia
- 518
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
Description of the hair dryer holder
I bought a small hair dryer with diameter of ca 6 cm and I could not find any fitting model of a holder. My requirements were: easy to print and attachable without using screws. Thus the design is in the end combination of a ring to which the hair dryer fits and a flat piece which can be held with the help of a double sided tape.
Printing
There are no supports required for the printing. 3 perimeters and 20 % infill should make the model sufficiently strong. I made mine from PLA but probably any material will work fine. If your hair dryer gets very hot from the outside as well it could be better to use PETG or ASA.
Conclusions
So far this holder serves me well. Make sure that your double sided tape is not weakened by moisture and that it can support some weight. If you would have any suggestions to this design, please, let me know – I will be happy to upgrade it.