Speed Square Belt Clip Sheath
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My take on a carpenter's speed square belt sheath. The square lies flat against your body with the wide side up.…
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 116
- Wydruki
- 0
- Wyświetlenia
- 813
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
My take on a carpenter's speed square belt sheath. The square lies flat against your body with the wide side up. There's a retention feature to keep the square from accidentally getting knocked out. The belt clip is sized for 2in (50mm) wide belts. I printed mine out of ASA for UV resistance, but PETG and ABS should work fine too, PLA might be too brittle for rough handling. Since I don't have an enclosure and my printer bed doesn't get very hot, I had a lot of warping on mine, and I had to print it in two parts and epoxy them together with aluminum reinforcements. If you have a larger printer and a better setup, yours will probably look nicer than mine.
Print Settings
Printer Brand:
Monoprice
Printer:
Select Mini
Rafts:
No
Supports:
Yes
Resolution:
0.131mm
Infill:
50% Gyroid
Filament: Polymaker PolyLite ASA Army Green
Notes:
Printed in 2 pieces with brims. Manual Supports or Support Blockers will probably be necessary in order to properly support the structure without putting supports in places they can't be cleaned out. Another strategy would be to print in multiple parts and glue together to minimize support cleanup.
Category: Tool Holders & Boxes